Varmeisolering

Komité: CEN/TC 89 (Thermal performance of buildings and building components)
Opprinnelse: SN
Sluttdato: 1. des 2022
Vis merVis mindre
 
This document specifies a test method for the in situ testing of the thermal performance of building structures especially built for the purpose of the test. This document also specifies the apparatus to be used and the measurement procedures to collect the data and the reporting format for the apparatus including the building test structure and the test conditions. NOTE The analysis of the data and the reporting format for the analysis are referred to in prEN 17888-2. This document does not apply to: - existing buildings; - building structures allowing direct solar gains through glazing surfaces; - the determination of the thermal performance of a specific building product, material, component or element.
Komité: ISO/TC 163/SC 1 (Test and measurement methods)
Opprinnelse: ISO
Sluttdato: 22. des 2022
Vis merVis mindre
 
The method of observing the condition of the insulation layer with visual inspection and also themethod of measuring the thermal conduction or resistance of the insulation layer, of the buildingelements such as exterior wall, floor, ceiling, etc. (hereinafter, walls) in the field is described.The proposed method is divided into the quantitative method which measures the thermal resistanceand the thermal conductivity with the heat flow measurement, and the qualitative method without heatflow measurement. The former quantitative method can apply not only the insulation layer but alsowhole throughout wall.This document especially aims to test the furnished insulation layer in the walls. It demonstrates ascreening test with drilling a small diameter borehole through the walls with the presumed insulationlayer. Visual inspection with a borescope and measuring the temperature distribution by inserting thetemperature sensor, the qualitative futures of the insulation layer is evaluated. Adding themeasurement of the heat flow rate, thermal conductance (resistance) is quantitively evaluated.
Komité: CEN/TC 156 (Ventilation for buildings)
Opprinnelse: SN
Sluttdato: 19. jan 2023
Vis merVis mindre
 
This document applies to the design, energy performance of buildings and implementation of ventilation, air conditioning and room conditioning systems for non-residential buildings subject to human occupancy, excluding applications like industrial processes. It focuses on the definitions of the various parameters that are relevant for such systems. The guidance for design given in this document and accompanying CEN/TR 16798 4 are mainly applicable to mechanical supply and/or exhaust ventilation systems. Natural ventilation systems or natural parts of hybrid ventilation systems are not covered by this document. Reference is made to the WI 00156243 (under development). Applications for residential ventilation are not covered in this document. Performance of ventilation systems in residential buildings are covered in EN 15665 and CEN/TR 14788. The classification uses different categories. For some values, examples are given and, for requirements, typical ranges with default values are presented. The default values are given in Annex B and a template for national specification is given in Annex A. Classification should always be appropriate to the type of building and its intended use, and the basis of the classification should be explained if the examples given in the European Standard are not to be used. NOTE 1 Different standards can express the categories for the same parameters in a different way, and also the category symbols can be different. Table 1 shows the relative position of this document within the set of EPB standards in the context of the modular structure as set out in EN ISO 52000 1. NOTE 2 In CEN ISO/TR 52000 2 the same Table can be found, with, for each module, the numbers of the relevant EPB standards and accompanying technical reports that are published or in preparation. NOTE 3 The modules represent EPB standards, although one EPB standard might cover more than one module and one module might be covered by more than one EPB standard, for instance a simplified and a detailed method respectively. See also Clause 2 and Table A.1 and Table B.1. Table 1 - Position of this document (in casu M5 1, M5 4), within the modular structure of the set of EPB standards ...