Ikkejernmetaller

Komité: CEN/TC 133 (Copper and copper alloys)
Opprinnelse:
Sluttdato: 21. mar 2019
Vis merVis mindre
 
This European Standard specifies the composition, property requirements and tolerances on dimensions and form for seamless round drawn copper and copper alloy tubes for general purposes supplied in the size range from 3 mm up to and including 450 mm outside diameter and from 0,3 mm up to and including 20 mm wall thickness. The sampling procedures and the methods of test for verification of conformity to the requirements of this European Standard are also specified. NOTE Tubes having an outside diameter less than 80 mm and/or a wall thickness greater than 2 mm in certain alloys are most frequently used for free machining purposes which are specified in EN 12168.
Komité: CEN/TC 132 (Aluminium and aluminium alloys)
Opprinnelse:
Sluttdato: 11. apr 2019
Vis merVis mindre
 
This European Standard defines the requirements for grades of alloyed aluminium ingots intended for remelting. It specifies the classifications and designations applicable to these grades, the conditions in which they are produced, their properties and the marks by which they are identified.
Komité: CEN/TC 133 (Copper and copper alloys)
Opprinnelse:
Sluttdato: 18. apr 2019
Vis merVis mindre
 
This document specifies a method for the estimation of the average grain size of copper and copper alloy products by ultrasound. This document can be applied for seamless round tubes as well as for flat products. This method can be used in place of test methods according to EN ISO 2624, mentioned in the relevant product standards. As reference method and in case of doubt the intercept procedure or planimetric procedure will be used.